Multi thematic blog dedicated to fun

johnny_jayz asked:


I live in California and received a “fix it” ticket for tinted front windows. I was wondering, if I don’t remove it and just pay the fine, how much will it be and will it go on my driving record?

No, I don’t want to remove it because it’s high grade commercial tint that I spent a lot of money for. It’s a flawless job and it keeps my car extremely cool.

Caffeinated Content

capusle j asked:


I have a bunch of very fine hairline scratches all over my front windshield from a microfiber towel.

How do i get rid of them?

Caffeinated Content

doitmyself asked:


When weather is less than app. 80 degrees I have internet service. When it gets hot I lose service. The cable company installed it on the eave of the roof, but laid the 75 ohm cable across the roof. I moved the cable so that it no longer ran across the roof and gained another couple of hours during the day of connection time.

One of the contractors they sent said that if we could use the outdoor cabling the company uses we would probably be fine, but the company won’t allow them to use it indoors.

Since we have no crawl space to run wires. Do they make heat resistant 75 ohm cabling? Or can I increase the signal to the cable modem with an amplifier. The cable company hasn’t offered any options except drilling through the walls, which really won’t help. I have 3 TV’s and my cable modem. TV pictures are fine. Internet service works great when it is up and running.

Any ideas?
Internet service goes down when sun is shining and above 80 degrees. ISP has been out and says house need to be rewired with new RG6 cable. I rerouted their installation so that 50′ of app.350′ of outside cable was no longer laying on roof of house (took 50′ off roof and ran that through eave of house and now I get about 2 more hours of internet service each day - TV service is always fine). ISP has checked signal coming to house from pole and says it is sufficient. They last guy out said that heat was a factor. I asked about a signal booster and they said they didn’t like to do that, but I have a friend who said they installed one for him. I think the run from the pole to the house is too long and since it is in full sun all day much of the signal is lost before it gets to me. I need someone with technical expertise to explain what’s happening. Does anyone have any ideas? Do you know of a cable from high heat installations? What kind of booster can I get to install in the house?
We can’t drill through wall because there are 3 TV’s and internet service in different rooms to they have to go throughout the house. Drilling would only bring it into one room.

Website content

Lasca asked:


I have a small pool and there’s a very fine silt settling on the bottom. I’ve tried using the pool vacuum to clean it, but the vacuum just stirs it up. While the filter is cleaning out a lot of it, it seems that most of it just ends up settling on the bottom again. I go through endless cycles of trying to vacuum with unsatisfactory results, and stirring the water to keep the stuff moving so the filter can have a chance to catch it. It seems my attempts are futile. Any ideas?

Pool Information:
- 10′diameter, 4′ deep (inflatable)
- Hard water (bacterial iron)
- Filters have been changed every 2 weeks (more if needed)
- Clarifier was added to try to get rid of the silt

Caffeinated Content

capusle j asked:


I noticed that i have very fine scratches on my car’s front windshield. They are extremely fine (cannot be felt with fingernail) and can only be seen if you shine direct lighting at it while doing a walkaround eyeing the same spot.

Are there any products that i can buy to apply onto the windhsield to get the scratches out???

Website content

George H asked:


I have an E36 and the BMW emblem is scratched. Can i sand with fine sandpaper and recoat it with clear paint?

Caffeinated Content - Members-Only Content for WordPress

http://www.wrightlawnv.com asked:


My toilet sometimes flushes fine but often does not and will overflow unless it is plunged fast enough.

Even when I dump a pale of water into the bowl, the toilet still will not flush unless I plunge it.

I do not think there is anything wrong with the toilet and am wondering if the plumbing may be the problem.

I have look into the common problems but cannot explain why it sometimes drains fine and other times overflows.
Is it possible that too narrow of drainage pipes could be causing this? Could it be that there is a vacuum buildup preventing the flushing?
The drainage lines were recently installed and so are clean. My concern may be that part of the drainage line may be too narrow at 2 inches.

I cannot explain why it sometimes flushes just fine.

Caffeinated Content